HAND TOOLS PROGRAMME

EUROPEAN MANUFACTURER SINCE 1919

Unior - Hand tools

Accessories for swiveling vice jaw 1693.1 and 1693.1S - 1693.12

Click to enlarge

Replacement of the spring with the screw, enables us to modify the jaw opening and pressure when closed. The screw can be turned with hand, without use of any wrenches.

Profile:

					Purchase request
623205	150	1V	1		add

Legend of symbols

Legend of symbols

	With a wrench unscrew the nut M8 (A) from the lever handle. ATTENTION while unscrewing: Spring is compressed and may pop out.
	Push the handle towards the jaw and pull out the handle lever (B) from the lever guide, then remove the spring (C).
	Unscrew the screws M4 (D) from the handle and remove the lever handle (E) which will not be required for the system with the screw.
	Insert new lever handle (shorter) (F) between the metal parts of the handle and fasten it on the handle with two screws M4 (G).
	Screw new setting nut M8 (H) to about half-way along the handle lever.
	Push the setting nut M8 (I) through the guide lever and with wrench 13 attach a new hex M8. While detain the nut wrench M8 (J) with other 13 wrench. Screw hex nut M8 so that there is a little gap between it and guide lever and that it is possible to screw or unscrew the nut.

1693.12.pdf

Packaging data

Retail tool packaging Transport package

	A	B	C			A1	B1	C1
623205	80	200	15	145	1	-	-	-	-

Legend of symbols

Legend of symbols

The page was printed from www.uniortools.com.
© 2005-12 Unior d.d. All rights reserved.