HAND TOOLS PROGRAMME

EUROPEAN MANUFACTURER SINCE 1919

Unior - Hand tools

Campagnolo Power and Ultra Torque full set, also for Fulcrum Ultra Torque - 1626A

Click to enlarge

This full set includes complete crank and bearing removal and installation tools for Campagnolo® and Fulcrum® Ultra Torque crank sets as well as for Campagnolo® Power Torque system.

Profile:

					Purchase request
623207	570	1E	1		add

Legend of symbols

Legend of symbols

	To remove the Campagnolo® Ultra Torque aluminum crank, we use the thin plate protector (F) which we firmly install between the crank and the bottom bracket cup. Afterwards we insert the pin extension (E) into the bottom bracket and with use of the universal puller (B), we remove the crank by turning the spindle (G) in the clockwise direction. The spindle can turned with use of a 19mm wrench or ratchet.
	To remove the Campagnolo® Power Torque carbon crank, the same procedure is used as with the aluminum crank, except that we must use the thicker plastic protector (D).
	To remove the bearing from the crank, we use the universal puller (B) together with the bearing removal extension (A).
	To install the bearing on the crank, we use the bearing installation tool (C) together with a hammer.

1626A.pdf

Packaging data

Retail tool packaging Transport package

	A	B	C			A1	B1	C1
623207	270	150	40	700	1	-	-	-	-

Legend of symbols

Legend of symbols

The page was printed from www.uniortools.com.
© 2005-12 Unior d.d. All rights reserved.